Fault Guide

Immobiliser Fault, Car Turns Over but Will Not Start

When the engine turns over but will not run, the immobiliser is not reading the key. Try the spare key first. If the spare starts the car, the fault is in the first key, not the car.

Updated November 2026·8 min read·By Ben Astle, AutoVault

Every car sold new in the UK since 1998 has an electronic immobiliser. It keeps the engine from running until the chip in the key sends the right code. A fault anywhere in that chain looks the same from the driver seat. The checks below find which part has failed and what the fix costs.

Starting prices for the fix
  • Key no longer recognised, coded again£60
  • New spare key cut and coded£145
  • Keyless smart key coded to the car£150
  • Antenna ring or module fault£150
  • Every key lost, new key made£180
  • Mercedes electronic ignition switch£250

These are AutoVault starting prices with no callout fee. The make, the model and the fault set the final figure, which is confirmed from the registration before the van sets off.

Car cranks but will not start?

Send the registration and what the dashboard shows, and the likely fix and price come back before the van leaves.

What Are the Signs of an Immobiliser Fault?

An immobiliser fault lets the starter turn the engine but stops it running. The signs below separate it from a flat battery or a starter fault.

What you seeWhat it points to
Engine turns over strongly but never firesImmobiliser refusing the key
Engine starts, then cuts out after a second or twoImmobiliser cutting the fuel once the code fails
Light shaped like a car with a key flashes or stays onChip not read or not recognised
Key not detected message on a push button carKeyless signal not heard, often a low fob battery
Doors lock and unlock but the car will not startRemote works, chip or immobiliser does not
Slow crank, dim lights or a clicking noiseCar battery or starter, not the immobiliser

What Should You Check First?

Four checks take a few minutes and often save a callout.

  1. Try the spare keyIf the spare starts the car, the first key has lost its chip or its coding, and the car itself is fine.
  2. Check the car batteryA slow crank or dim lights mean the battery is too weak for the immobiliser to read the key. Charge or replace it before anything else.
  3. Hold a keyless fob against the start buttonOn most push button cars this lets the car read a fob with a flat battery. If it starts, a new fob battery is the fix.
  4. Lock and unlock with the remote, then try againOn some makes this clears a passing fault. If the light still flashes after two tries, stop, because repeated attempts can flatten the car battery.

What Causes an Immobiliser Fault?

Five faults cause almost every case, and the first one is the cheapest to put right.

The chip in the key is not read

A key that has been dropped, soaked or cracked can lose its chip or the contact around it, while the blade still turns the lock. The car then sees a key with no code. The chip in a transponder key has no battery of its own, so a new fob battery will not bring it back, but a working chip can be coded again from £60.

The antenna ring around the ignition

A coil around the ignition barrel, or a reader by the start button on keyless cars, sends a weak signal that wakes the chip. When that ring fails, every key stops working at once, even a brand new one. Antenna ring faults start from £150.

A flat or changed car battery

Low voltage can stop the immobiliser reading the key, and on some cars a flat battery or a battery change corrupts the module memory that holds the key codes. Jaguar and Land Rover models show this most often.

A key made for another car or never coded

A key bought online or cut at a counter turns the lock but starts nothing until its chip is coded to the immobiliser. That is a coding job from £60, as long as the key matches the car.

A module or ECU fault

The body control module or the engine ECU can lose the data that links them to the keys. The keys are fine, the car has forgotten them, and the data is repaired or the keys are coded again at module level.

Why Have Both Keys Stopped Working at Once?

When both keys fail on the same day, the fault is in the car, not the keys. Two keys rarely break together, so the shared parts are the place to look.

Shared partWhy it stops both keysFrom
Car batteryToo little voltage to power the readerBattery first
Antenna ring or keyless readerNo signal reaches either chip£150
Body control module dataThe car no longer holds the key codes£150
Mercedes electronic ignition switchThe switch stops reading or turning any key£250

A new key will not cure any of these, which is why a car where both keys fail needs the fault found first and a key made second.

Can You Reset or Bypass an Immobiliser?

There is no owner reset on most cars, and a bypass is not a fix. Locking and unlocking with the remote can clear a passing fault on some makes, and some handbooks set out a key sequence for their own model. A key the car has stopped recognising has to be coded again with diagnostic equipment at the car.

A bypass removes the security the car was built with, and it can void the insurance and make the car easier to steal. AutoVault repairs the fault and keeps the immobiliser working.

How Much Does an Immobiliser Fault Cost to Fix?

The fix costs from £60 when the key only needs coding again, and from £150 when a part of the car has failed.

FaultFixTime at the carFrom
Key no longer recognisedKey coded again15 to 30 minutes£60
Chip dead or key lost, spare leftNew key cut and coded15 to 30 minutes£145
Keyless fob not readNew smart key coded15 to 30 minutes£150
Antenna ring or module dataPart replaced or data repairedSet once the fault is found£150
Every key lostNew key made from the carUp to 1.5 hours£180
Mercedes electronic ignition switchSwitch repairedSet once the fault is found£250

Mercedes cars with FBS4 from 2015 are the one exception, as only a Mercedes dealer can make keys for them.

How Can You Stop an Immobiliser Fault Coming Back?

  1. Keep a working spareA second coded key turns a car that will not start into a two minute test, and a spare from £145 costs less than a key made from nothing at £180.
  2. Look after the car batteryA battery that cranks slowly in the cold is the most common cause of a false immobiliser fault, and on some cars it can corrupt the key data when it goes flat.
  3. Keep keys dry and in one pieceWater and a cracked head are the usual ways a chip stops being read, so a split case is worth replacing before the chip inside works loose.
  4. Change the fob battery earlyA keyless fob that needs pressing twice or works only up close is giving warning before it stops starting the car.

Who Fixes Immobiliser Faults in Staffordshire?

AutoVault fixes immobiliser faults at the car across Staffordshire, from the base in Uttoxeter, about 25 to 45 minutes from most towns, with no callout fee, so a car that will not start does not need a recovery truck.

Keys coded at the car

A key the car has stopped recognising is one of the car keys programmed on site, with the original kept working where it can be.

Module and ECU faults

When the car has lost its key data, the work moves to car module repair, done at the car with the module kept in place wherever it can be.

Immobiliser Fault Questions Answered

Not with the key it has stopped recognising. If the spare key starts the car, the fault is in the first key, and if neither key works, the fault is in the car and has to be found and fixed before it will run.

By finding which part has stopped talking, the key, the antenna ring or a module, and fixing that part. A key the car no longer recognises is coded again from £60, while an antenna ring or module fault starts from £150 with AutoVault.

From £60 with AutoVault when the key only needs coding again, and from £150 for an antenna ring or module fault. A new key starts from £145, and every key lost starts from £180, with no callout fee.

There is no owner reset on most cars. Locking and unlocking with the remote can clear a passing fault on some makes, but a key the car has stopped recognising has to be coded again with diagnostic equipment.

Yes. A weak car battery can stop the immobiliser reading the key, and on some cars a flat or changed battery corrupts the module memory that holds the key codes. Charge or replace the battery first, then try both keys.

The car cannot hear the keyless signal, most often because the fob battery is low. Hold the fob against the start button or the marked spot, and if the car then starts, a new fob battery usually ends the message.

Almost certainly, because an electronic immobiliser has been required on every new car sold in the UK since 1998. Older cars may have one fitted later, which usually shows as a separate fob or a light on the dashboard.

If the engine starts and keeps running, the immobiliser has accepted the key and the car can be driven. A light that stays on or flashes while driving points to a fault that is worth checking before the car refuses to start.

Only when the key is the fault. If the spare key starts the car, a new or recoded key fixes it, but if both keys fail, the fault is in the car and a new key will not help.

Coding a key the car no longer recognises takes 15 to 30 minutes at the car. Making a new key with every key lost takes up to 1.5 hours, and module faults are timed once the fault is found.

No. AutoVault charges no callout fee anywhere in Staffordshire, so the price is for the fix alone, from £60, and it is confirmed from the registration before the van sets off.

Car will not start in Staffordshire?

Call with the registration and what the dashboard shows, and the fix and the price are confirmed before the van sets off, with no callout fee.

Scroll to Top