Broken Key Extraction in Staffordshire
Broken key extraction in Staffordshire from £80, with Ben at your car in about 25 to 45 minutes.
Ben Astle of AutoVault removes broken car keys from door locks, boot locks and ignition barrels at your car across Staffordshire, from Uttoxeter to Stoke-on-Trent. He draws the snapped blade out through the keyway without drilling where it can be avoided, then cuts and programmes a new key in the same visit if you need one, with no call-out fee.
The broken piece comes out without damage to the lock, and a new key can be cut at the car in the same visit.
Can a Broken Car Key Be Removed Without Damaging the Lock?
Yes, a broken car key can usually be removed without damaging the lock, because the snapped blade is drawn back out through the keyway rather than drilled. Broken key extraction means a thin tool slides into the keyway beside the blade, catches one of its cuts and pulls the fragment straight out, so the lock stays in the door or the steering column.
The fragment stays stuck because the spring loaded wafers inside the lock press into its cuts, and there is no head left to grip. Ben carries hook picks, extractor spirals and slide hammer extractors, and matches the tool to the lock and to where the fragment sits. Most straightforward extractions take 15 to 30 minutes.
Once the blade is out, the two pieces show the cuts, so a new blade can be made from them by car key cutting, or a complete new key cut and programmed in the same visit.
Call or WhatsApp Ben with your location, make and model before trying anything yourself. He attends across Staffordshire with the extraction tools.
What Should You Do If Your Car Key Has Snapped in the Lock?
Stop, keep both pieces, note where it broke and call. These four steps keep the fragment where it is and make the extraction quicker.
Stop Turning and Pulling
Leave the fragment exactly as it sits. Every attempt with pliers, a pin or a screwdriver pushes the blade deeper or turns it out of line with the keyway.
Keep Both Pieces Together
The head holds the chip and often the remote, and the broken blade shows the cuts, so both help Ben make the new key.
Note Where It Broke
Say whether the broken end sticks out, sits level with the lock or sits deep inside, and which position the ignition was in when it snapped.
Make the Car Safe, Then Call
At the roadside, put the hazard lights on and wait somewhere safe, then call or WhatsApp Ben with the make, model and registration.
Why Do Car Keys Snap Inside the Lock?
The break usually comes at the thinnest point, a deep cut or the place where the blade meets the head. Turning the key while the steering lock is on puts the blade under the same strain. A key that has to be jiggled, a bent blade and a lock that keeps getting stiffer are the warning signs before a snap. How hard the extraction is then depends on where the fragment broke, what position it is in and whether anything has been pushed in after it.
Is a Key Broken in the Ignition Harder to Remove Than One in a Door Lock?
Yes, usually. A door lock is the easiest place to reach a fragment, while an ignition barrel is deeper and often stops in a turned position.
Door Lock Cylinder
The most accessible location. Extraction hooks reach the fragment through the keyway if it has not been pushed in or turned out of line, and non-destructive removal works in most cases.
Ignition Barrel
Deeper and harder to reach, and often held in a turned position. The barrel is brought back to the position a key comes out in, and checked for damage from the snap or from home attempts.
Boot or Fuel Cap Lock
Less common, but the same method applies. Smaller cylinders leave less room to work, and the extraction tools cover these too.
When Drilling Becomes Necessary
A fragment that is buried, turned sideways or held by corrosion or glue cannot always come out through the keyway. Drilling destroys the barrel, so Ben tries extraction first and tells you before drilling is the only option left.
⛔ What Not to Try Before Ben Arrives
- Do not hook it out with a wire or pin. It pushes the fragment further in and can turn it out of line with the keyway.
- Do not spray lubricant into the lock. Household sprays make the fragment slippery, so extraction tools slip on it.
- Do not turn the part still in the lock. Turning it breaks the snapped edge up further and can jam the barrel.
- Do not use superglue to join the pieces. Glue can bond the blade to the wafers, and then it cannot be drawn out at all.
- Do not push a spare key into the same lock. The fragment fills the keyway, and both keys can jam together.
How Much Does Broken Key Extraction Cost?
Broken key extraction in Staffordshire starts from £80 in 2026 for a door or boot lock and from £150 for an ignition barrel, and a new blade cut from the broken pieces starts from £50 on top. Ben confirms the full price before he travels, and there is no call-out fee. Every key and repair comes with a six month warranty, and you can pay by cash, card, Google Pay or Apple Pay.
Where the fragment sits, which lock it is in and whether anything has been pushed in after it set the extraction figure. Whether you need a new key afterwards, and whether another working key is at the car, sets the rest. Barrel work, where the barrel itself is at fault, is priced separately once it has been checked.
Broken key extraction prices, 2026
| Job | When it applies | From |
|---|---|---|
| Broken key extraction, door or boot lock | The fragment is drawn out of a door, boot or fuel cap lock | £80 |
| Broken key extraction, ignition barrel | The fragment sits in the ignition, which is deeper and often turned | £150 |
| New blade cut from the pieces | The head, chip and remote still work and only the blade is lost | £50 |
| New key cut and programmed | The old key cannot be reused and another working key is at the car | £145 |
| New key with no working key | The snapped key was the only key and cannot be reused | £180 |
What Happens After the Broken Key Is Out?
The empty lock is turned through its positions first, so a worn barrel is found before a new key meets the same resistance. Then you get the cheapest outcome that leaves you with a working key.
The Remaining Key Still Works
If the key broke at the very tip and the rest of the blade is still usable, extraction alone puts things right.
A New Blade Cut From the Pieces
The fragment and the remaining piece are used together to trace the full blade and cut a new one, and on most flip keys it fits the existing head.
A Complete New Key
If the key cannot be traced or a new key is needed anyway, Ben cuts and programmes one in the same visit.
Barrel Work, Only If Needed
If the barrel was damaged by the break, by a seized mechanism or by home attempts, Ben advises whether it can be saved before any further work.
How Ben Got a Seized Ford Transit Running Again in Stone
A 2018 Ford Transit with the key held fast in a seized ignition barrel, running again on site in 40 minutes.
The ignition barrel on the van had seized with the key inside, so the key would neither turn nor pull out cleanly. Ben built a new barrel to suit the existing key and had the van running again in 40 minutes, with no tow or recovery needed. What looks like a key problem is sometimes a barrel problem, which is why the lock is always checked once a key or fragment is out.
What Else Should You Know About a Snapped Car Key?
A few questions come up on most broken key calls, and each is answered here in a sentence or two.
Is It the Key or the Ignition Barrel?
Sometimes both. A barrel that stays stiff once the fragment is out has its own fault, and that work is ignition repair and replacement.
Does a Spare Key Work While the Fragment Is in the Lock?
Not in that lock, because the broken blade fills the keyway. A fragment in a door lock leaves the ignition clear, so the spare still starts the car.
Can You Drive With Part of the Key in the Ignition?
No. Even if the engine starts, the fragment can shift and jam the barrel, so leave the car until the piece is out.
Why Do More Keys Snap in Winter?
Cold stiffens a lock, so the key needs more force to turn, and a blade already worn thin gives way under it.
How Do You Stop the Next Key Snapping?
Replace a worn or bent key before it fails, never force a stiff lock, and keep locks turning freely with a graphite or silicone lock lubricant once a year.
Is One Key Enough After an Extraction?
No, if it is your only key. A spare car key made while a working key is there costs far less than a new key after the last one fails.
Non-destructive first, drilling only as a last resort. Ben always tries the least destructive option and tells you honestly when extraction is not possible without drilling.
Specialist Extraction Tools
Hook picks, extractor spirals and slide hammer extractors, with the tool matched to the lock and to where the fragment sits.
Ben Answers and Attends Directly
No call centre. Ben answers his own phone and can tell you whether the job is likely to be straightforward before he attends.
New Key Cut in the Same Visit
If a new key is needed after extraction, Ben carries the cutting and programming equipment to finish the whole job in one visit.
DBS Checked and Insured
Current DBS check and £5 million public liability insurance, and SERMI approved for vehicle security access.
What Do Customers Across Staffordshire Say About Ben?
Frequently Asked Questions About Broken Key Extraction
Call or WhatsApp Ben straight away, before any home attempts make extraction harder. No call-out fee, anywhere in Staffordshire.