Fault Guide

Key Will Not Turn in the Ignition? Causes and Fixes

A key that will not turn in the ignition is held by the steering lock, a gear selector out of Park, a worn key or a worn ignition barrel. Turn the steering wheel gently while you turn the key before you try anything else.

Updated November 2026·6 min read·By Ben Astle, AutoVault

Most of these faults clear in a minute where the car is parked. The checks below run in the order that frees the most cars first. Each one says when to stop, because a forced key is how a worn blade ends up snapped inside the barrel.

Try these four checks first

  1. Rock the steering wheelTurn the wheel firmly towards the side that gives a little, and hold it there while you turn the key. The lock pin lets go and the key turns.
  2. Check the gear selectorAn automatic has to sit fully in P, and many need the brake pedal pressed as well. A manual is safest in neutral.
  3. Try the spare keyIf the spare turns, the first key is worn. If the spare sticks too, the barrel or the lock is the cause.
  4. Look at the key itselfA bent blade or rounded cuts stop the wafers lining up. Push the key fully in and keep it straight as it turns.

Key still will not turn?

AutoVault comes to the car, about 25 to 45 minutes in most Staffordshire towns, with no callout fee.

Why Will the Key Not Turn in the Ignition?

Seven faults are the usual causes, and the first three cost nothing to fix. The rest need a new key, a barrel repair or a check of the electrics.

The steering lock has engaged

Turning the wheel after the engine stops drops a steel pin into the column, and that pin also holds the barrel. Parking with a front wheel against a kerb adds pressure to it. Rocking the wheel while turning the key takes the load off the pin.

The gear selector is not in Park

An automatic gearbox has a shift lock that stops the key turning unless the selector is fully in P. Move the selector out and back into P, press the brake pedal, then try the key again.

The key blade is worn or bent

Years of use round off the cuts and the shoulder that stops the key at the right depth. A worn key often turns only part of the way or only when wiggled. A new key cut to the key code brings the blade back to its original shape.

The ignition barrel is worn or dirty

The small wafers inside the barrel wear in step with the key, and dust or grit can stop them moving. When no key turns, including the spare, the barrel is the likely fault.

The battery is flat

Cars with an electronic steering lock or an automatic shift lock need power to release them. A dark dashboard and no interior light point to the battery before the key.

The electronic steering lock has failed

Some cars lock the column with a small motor instead of a pin. When the motor or its control unit fails, the key or the start button does nothing even with a good battery, and the lock needs repair and coding.

The key is from another car

A similar key from a second car, a van on the same fleet or an old spare can go into the barrel without turning it. Check the key matches the car before blaming the lock.

How Do You Free a Locked Steering Wheel?

  1. Push the key fully inA key that sits slightly out cannot turn even when the lock is free.
  2. Find the side that givesTurn the wheel left and right. One way moves a little before it stops.
  3. Hold the wheel and turn the keyKeep firm pressure towards that side and turn the key gently at the same time.
  4. Stop after a few triesIf the lock still holds, the barrel or an electronic lock is the cause, and more force only adds damage.

What Should You Never Do to a Stuck Ignition?

Four things that turn a small fault into a big one

  • Pliers or a spanner on the key. The extra leverage snaps a worn blade inside the barrel.
  • Oil or a wet spray in the barrel. It holds dust and gums the wafers. Only a dry lubricant made for locks is safe.
  • A hammer on the key. Tapping it in bends the blade and cracks the barrel face.
  • A different key forced in. A key cut for another car scores the wafers and can jam the barrel shut.

Is It the Key or the Ignition Barrel?

The spare key answers this in seconds. Match what you see to the row below, and the starting price tells you what the fix costs with AutoVault at the car.

What you seeLikely causeFix at the carFrom
Spare key turns, main key does notWorn keyNew blade cut to the key code£50
Spare key turns, main key needs replacingWorn key with a chipNew key cut and programmed£145
No key turns, wheel moves freelyWorn or jammed barrelBarrel repaired or replaced to fit your key£150
Key turns part way, then sticksWorn barrel wafersBarrel repair£150
Blade snapped inside the barrelBroken keyPiece removed, new key cut£80
Dark dashboard, no key turnsFlat battery or electronic lockBattery first, then the lock checked£150

When no key turns and the wheel moves freely, the fault sits in the barrel, and a replacement ignition barrel is built to fit your existing key, so one key still opens the doors and starts the car.

What If the Key Turns but the Car Will Not Start?

That is a different fault. The key turns, so the lock and the barrel are working, and the immobiliser is not reading the chip inside the key. A key light that flashes on the dashboard is the usual sign. Try the spare key first, because a spare that starts the car confirms the chip, and pairing it again costs from £60.

When Should You Call an Auto Locksmith?

Call once the four checks have failed, or straight away when the key has snapped, the barrel spins without the key or the dashboard shows a steering lock warning. AutoVault works at the car across Staffordshire, about 25 to 45 minutes in most towns, with no callout fee, and the price is confirmed from the registration before the van leaves.

A key snapped in the barrel

Part of the blade left inside stops any key turning, and pulling at it pushes it deeper. The piece comes out with broken car key extraction across Staffordshire, and a new key is cut on the same visit when the old one cannot be used.

Volkswagen, Audi and Skoda cars

Older Golf, Polo, A3 and Octavia models wear their barrels in a known pattern, where the key turns less and less over a few weeks. The signs and the fix are set out for VW, Audi and Skoda ignition barrels.

Key Will Not Turn Questions Answered

Turn the steering wheel firmly towards the side that gives while you turn the key, which frees most steering locks in seconds. Then check the gear selector is in Park and try the spare key, and stop before forcing anything, because removing a snapped blade costs from £80.

No, not oil or a wet spray. A wet lubricant holds dust and gums the wafers inside the barrel, so only a small puff of dry lubricant made for locks is safe, and a barrel that is already worn still needs repair from £150.

Push the key fully in, then turn the steering wheel towards the side with a little play while you turn the key gently. Most steering locks release on the first or second try at no cost, and a lock that never frees points to a barrel or electronic lock fault, checked at the car from £150.

The key or the barrel is the cause when the wheel moves freely. A spare that turns means the first key is worn and a new blade is cut from £50, while a spare that sticks too means a worn barrel, repaired from £150.

Yes, on cars with an electronic steering lock or an automatic gearbox shift lock. Both need 12 volt power to release, so a dark dashboard points to the battery first, and a jump start often frees the key with no repair at all.

No. Forcing a worn key snaps the blade inside the barrel, and removing the broken piece then costs from £80 before a new key can be cut.

Put the gear selector in Park, turn the key back to the off position and keep it straight as you pull. If it still holds after 2 or 3 gentle tries, the barrel needs attention from £150 rather than more force.

No, not in most cases. The steering lock, the gear selector or a worn key clear without any new parts, and a barrel is only replaced, from £150, when the spare key will not turn either.

It means the lock motor or its control unit no longer releases the column, so the key or the start button does nothing even with a charged battery. On Mercedes cars this is handled by Mercedes ESL and ELV steering lock repair, and other makes are checked at the car from £150.

The immobiliser is usually not reading the chip in the key, while the lock and the barrel are working. A spare key that starts the car confirms it, and key programming at the car pairs the chip again from £60.

With AutoVault it costs from £50 for a new blade cut to the key code and from £150 for an ignition barrel repaired or replaced to fit your key. There is no callout fee in Staffordshire, and the price is confirmed from the registration before the van leaves.

Key stuck in Staffordshire?

Call with the registration and where the car is parked, and the price is confirmed before the van sets off, with no callout fee.

Scroll to Top